– 5% to 90% RH, Non-Condensing, for temperatures 0☌ to 40☌.Environmental & Electrical Specifications This product is designed to be used in combination with the AcraDyne iEC DC tool controller for intermittent hand-held or fixtured assembly processes.Any power tool that cannot be controlled with the switch is dangerous and must be repaired. Do not use the power tool if the switch does not turn it on and off.The correct power tool will do the job better and safer at the rate for which it was designed. Use the correct power tool for your application. Use of these devices can reduce dust-related hazards. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used.Loose clothes, jewelry or long hair can be caught in moving parts. Keep your hair, clothing and gloves away from moving parts. This enables better control of the power tool in unexpected situations. Keep proper footing and balance at all times. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. Remove any adjusting key or wrench before turning the power tool on.Carrying power tools with your finger on the switch or plugging in power tools that have the switch on invites accidents. Ensure the switch is in the off-position before plugging in. If the maximum duty cycle of the attached tool is exceeded or the tool temperature exceeds 50° C., then the operator should wear protective hand wear (gloves). Safety equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. A moment of inattention while operating power tools may result in serious personal injury. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. Stay alert, watch what you are doing and use common sense when operating a power tool.Failure to exercise caution and correct operating technique can result in serious personal injury, loss of limb or death. Damaged or entangled cords increase the risk of electric shock. Keep cord away from heat, oil, sharp edges or moving parts. Never use the cord for carrying, pulling or unplugging the power tool.

Water entering a power tool will increase the risk of electric shock. Do not expose power tools to rain or wet conditions.There is an increased risk of electric shock if your body is earthed or grounded. Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators.Unmodified plugs and matching outlets will reduce risk of electric shock. Do not use any adapter plugs with earthed (grounded) power tools. Power tool plugs must match the outlet.

112 operator the last duty ending